Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

水处理中微生物絮凝剂产生菌的选育及应用

综述了微生物絮凝剂产生菌筛选和培育方面的研究进展,介绍了微生物絮凝剂在给水和饮用水、乳化液的油水分离、污水处理等领域的应用,以及廉价培养基的探索实践。提出针对影响微生物絮凝剂产生菌生长代谢的环境条件开展深入研究,同时寻找或设计廉价培养基,降低生产成本,推动其工业化应用。     

煤制乙二醇废水预处理装置的工业化调试

针对煤制乙二醇废水含高浓度硝酸盐氮的特点,设计了缺氧膨胀床(AEB)反应器预处理装置,并进行了工业化启动和调试运行,考察了其在反硝化连续流运行条件下的处理效果及工艺参数变化。结果表明,AEB反应器启动后,填料层生物膜挂膜快速且生长稳定。反应器在工业化调试阶段运行稳定,COD和TN的去除率和去除负荷较为稳定。在受到来水冲击后,AEB反应器处理效果稳定,出水可在短期内恢复正常。该技术的系统操控参数范围较广,易于工业化操控运行,在煤制乙二醇废水和其他含高浓度硝酸盐氮废水的处理中具有较大的推广价值。     

城市大气中挥发性有机化合物监测技术进展

挥发性有机物(VOCs)是臭氧及二次有机颗粒物(SOA)的主要前体物。近年来,我国逐步将VOCs纳入大气污染物控制体系。准确可靠的监测技术是大气VOCs研究及控制的重要前提保障。按照采样方法、分析方法 2个方面介绍并讨论了城市大气中VOCs的现有监测方法,较为详细地介绍了几类广泛采用的离线及在线监测技术,简要讨论了目前VOCs监测中存在的一些问题,展望了今后的发展趋势。     

Degradation of polycyclic aromatic hydrocarbons by combined chemical pre-oxidation and bioremediation in creosote contaminated soil

The ability of pre-oxidation to overcome polycyclic aromatic hydrocarbons (PAH) recalcitrance to biodegradation was investigated in creosote contaminated soil. Sand and peat artificially spiked with creosote (quality WEI C) were used as model systems. Ozonation and Fenton-like treatment were proved to be feasible technologies for PAH degradation in soil. The efficiency of ozonation was strongly dependent on the water content of treated soil samples. The removal of PAH by Fenton-like treatment depended on the applied H2O2/soil weight ratio and ferrous ions addition. It was determined that the application of chemical oxidation in sand resulted in a higher PAH removal and required lower oxidant (ozone, hydrogen peroxide) doses. The enhancement of PAH biodegradability by different pre-treatment technologies also depended on the soil matrix. It was ascertained that combined chemical and biological treatment was more efficient in PAH elimination in creosote contaminated soil than either one alone. Thus, the combination of Fenton-like and the subsequent biological treatment resulted in the highest removal of PAH in creosote contaminated sand, and biodegradation with pre-ozonation was found to be the most effective technology for PAH elimination in peat.     

湖州市埭溪镇污水处理厂的工程设计

湖州市埭溪镇污水处理厂的设计规模，近期为2万m^2／d，远期为3万m^2／d，其污水处理工艺采用改良式A^2／O工艺，污泥处理工艺采用带式浓缩脱水一体机。文中着重介绍了工程设计参数、处理工艺流程及其设计特点。     

Fate of cancerostatic platinum compounds in biological wastewater treatment of hospital effluents

The present work focuses on the fate of two cancerostatic platinum compounds (CPC), cisplatin and carboplatin, as well as of two inorganic platinum compounds, [PtCl₄]²⁻ and [PtCl₆]²⁻ in biological wastewater treatment. Laboratory experiments modelling adsorption of these compounds onto activated sludge showed promising specific adsorption coefficients K_D and K_OC and Freundlich adsorption isotherms. However, the adsorption properties of the investigated substances were differing significantly. Adsorption decreased following the order cisplatin > [PtCl₆]²⁻ > [PtCl₄]²⁻ > carboplatin. Log K_D-values were ranging from 2.5 to 4.3 , log K_OC from 3.0 to 4.7.

A pilot membrane bioreactor system (MBR) was installed in a hospital in Vienna and fed with wastewater from the oncologic in-patient treatment ward to investigate CPC-adsorption in a sewage treatment plant. During three monitoring periods Pt-concentrations were measured in the influent (3–250 μg l⁻¹ Pt) and the effluent (2–150 μg l⁻¹ Pt) of the treatment plant using ICP-MS. The monitoring periods (duration 30 d) revealed elimination efficiencies between 51% and 63% based on averaged weekly input–output budgets. The derived log K_D-values and log K_OC-values ranged from 2.4 to 4.8 and from 2.8 to 5.3, respectively. Species analysis using HPLC-ICP-MS proofed that mainly carboplatin was present as intact drug in the influent and – due to low log K_D – in the effluent of the MBR.     

生态土壤渗滤系统启动周期研究

利用室内模拟试验装置,考察了4种生态土壤渗滤系统在0.1 m3/(m2·d)的水力负荷条件下对生活污水中TP、COD和NH3-N的去除效果及启动周期; 同时对整个系统及同类生态工艺启动周期的判断方法做了探讨.研究结果表明,生态土壤渗滤系统对TP、COD和NH3-N的启动周期分别为15～27 d、24～40 d和24～26 d; 土壤渗滤系统对TP的启动周期最短,对COD的启动周期最长; 处理系统启动周期的判断原则是综合考察系统对主要污染物各自的启动周期,以最长的作为系统启动周期.4组试验中,1#和2#系统的启动周期为40 d; 3#和4#的为24 d.     

用海泡石处理采油废水

用海泡石吸附法处理采油废水，考察了处理时间、海泡石加入量和采油废水pH对采油废水COD去除率的影响，并通过正交实验优化了采油废水处理工艺条件。通过正交实验得到的采油废水处理最佳工艺条件为：处理时间6h，粒径为150μm的海泡石加入量200g／L，采油废水pH9。在该条件下处理采油废水，COD去除率达到91％，处理后出水的COD为34．71mg／L，小于GB8978-1996（（污水综合排放标准》中的一级标准（60mg／L）。     

郑州市春季大气污染过程VOCs特征、臭氧生成潜势及源解析

利用GC5000在线气相色谱仪于2018年4月15日～5月15日对郑州市城区环境大气挥发性有机物(VOCs)进行监测,开展其污染特征、臭氧生成潜势(OFP)和来源解析研究.结果表明,监测期间,郑州市春季VOCs平均体积分数为40.26×10~(-9),非污染日和污染日VOCs平均体积分数分别为35.82×10~(-9)和44.12×10~(-9),污染日相较非污染日增长23%;VOCs物种对OFP的贡献表现为烯烃芳香烃烷烃炔烃;源解析结果显示监测期间郑州市VOCs主要来源是LPG源(66.05%)、机动车源(47.39%)、工业溶剂源(37.51%)、燃烧源(37.80%)和植物排放源(11.25%),且污染日的LPG源和植物排放源的贡献率较非污染日增长22.92%和68.50%.